Matrox M.Key/100 Installationshandbuch PDF herunterladen (Seite 19)

Chapter2　Installing Windows Server 2008

Manual OS Installation

2.1.2 Configuring Array

When you operate with array configurations, configure arrays first before you install OS.

1 Turn on the server.

2 Configure an array.

The method differs depending on your array controller.

For Onboard Software RAID (Embedded MegaRAID SATA)

When the following message appears, press the [Ctrl] + [M] keys or the [Enter] key.

SATA Setup Utility starts up, and Management Menu appears.

For details, refer to "Embedded MegaRAID SATA User's Guide" in Array Controller Document & Tool CD.

For SAS controller card or onboard IM (Integrated Mirroring SAS)

When the following message appears, press the [Ctrl] + [C] keys.

BIOS Utility starts up.

For details, refer to "Integrated Mirroring SAS User's Guide" in Array Controller Document & Tool CD.

For SAS array controller card (MegaRAID SAS)

When the following message appears, press the [Ctrl] + [H] keys.

WebBIOS starts up.

For details, refer to "MegaRAID SAS User's Guide" in Array Controller Document & Tool CD.

3 Turn off the server.

2.1.3 Cautions for unconfigured array

When a SAS array controller card has been installed when not building an array using PRIMERGY

ECONEL100 S2, change the BIOS setting [SATA RAID Enable] to "Disabled".

The installation is not normally completed if it doesn't change to "Disabled".

SAS Ctrl (PG-224B/PG-228B) Install it from PCI-Express SAS Card Document & Tool CD.

Other expansion card Driver attached with each expansion card

Press Ctrl-M or Enter to run LSI Software RAID Setup Utility.

Press Ctrl C to start LSI Logic Configuration Utility

Press <Ctrl><H> for WebBIOS

Onboard LAN / Expansion card Driver

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Keine Kommentare

Matrox M.Key/100 Installationshandbuch Seite 19